How To Configure Repeater Mode?

a repeater is an essential electronic device used in telecommunications and networking to extend the range of signals or overcome obstacles that hinder signal transmission it acts as an intermediary between the transmitting device and the receiving device, receiving the incoming signal, amplifying it, and retransmitting it to its intended destination the primary purpose of a repeater is to extend the transmission distance of signals when a signal travels over a communication medium, such as a cable or a wireless channel, it gradually weakens due to factors like attenuation and interference as a result, the signal becomes too weak to reach its intended destination, leading to data loss or communication failure by receiving and amplifying the weakened signal, a repeater boosts its strength and retransmits it, effectively extending the reach of the signal pre condition pre condition in order to set up the repeater, the xunison router must have internet access in order to set up the repeater, the xunison router must have internet access follow the below steps to set up the repeater mode step 1 select "smart home" select "smart home" from the dashboard step 2 settings select "settings" from the left navigation bar step 3 start wizard click on "start wizard" step 4 select "repeater" to set up the repeater mode, select the mode "repeater" click on "scan" as indicated important important avoid choosing the xu ssid for setting up the repeater mode avoid choosing the xu ssid for setting up the repeater mode select the ssid and enter the password for which you want to set up repeater mode step 5 submit click on "submit" step 6 repeater set up complete the repeater mode has been successfully set up the configuration setup has been completed please be aware that once the repeater mode is configured, it is necessary to disconnect the wan cable from the router please be aware that once the repeater mode is configured, it is necessary to disconnect the wan cable from the router